Australian Designed Precision Blade Sharpening

Just Good Gear

How to assemble your Knifemate

Step 1

Wind the Jack Bar (3) into the Jaw Bar (1).  Continue winding until approximately half way down the threaded section of the Jaw Bar.

Step 2

Wind the Lock Nut (4) onto the Jack Bar (3).  There is no need to tighten the Lock Nut at this stage.

Step 3

Knifemate is now assembled and ready for use.  In the videos section (see videos tab on the home page) you can view how to grip a blade with Knifemate and the other stages of the sharpening process.


Knife Supplies Australia
PO 88 Kingston TAS 7051

Phone: 03 6229 4339


Trade Enquiries Welcome

Privacy Policy

Ask a question or leave feedback.

If you have any questions or feed back about Knifemate or would like further information please contact us below and we will get back to you shortly.